Alesis airSynth Specifikace stáhnout pdf (Strana 25)

Performance: Chapter 3

28 AIRSYNTH REFERENCE MANUAL

A decimal point has appeared between the first and second digits of the

program number, showing that the Hold function is set.

When you’ve entered Hold mode, you can move your hand around the sensor to

modulate the loop. On some programs, your hand controls the balance between

the instruments. On others, your hand changes the octave of the bass line or

filters the loop.

Pressing the Program knob again exits the Hold function and allows

you to create a new loop.

In summary, to make a new sequence:

1. (Optional:) Select the “--“ program to set the tempo of the loop.

See “The Tempo Program” section later in this chapter. (If the

tempo is not set, the unit will operate at 120bpm upon power-

up.)

2. Select the Program you want to sequence, number 2 or 42-45.

3. Play the drum sounds or pitches by approaching the sensor

from different sides.

4. When you’re finished adding notes, press and hold the Program

knob to enter Hold mode.

5. Move your hand around the sensors to modulate the loop

you’ve created.

6. To start over, press the Program knob again to turn off the Hold

function.

Pads

Programs 1, 5, 6, 7

These programs allow you to select a pitch, then move around the

sensors to change the timbre. The trick is to approach the sensor from a

different direction when you want a new pitch.

To use these programs:

1. Approach the sensor from one of its sides. For example, approach

from the left.

2. Twist your hand around the sensors to filter and modulate the

sound.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Žádné komentáře

Alesis airSynth Specifikace Strana 25