Alesis 24 Specifikace stáhnout pdf (Strana 16)

Introduction

STUDIO 24 REFERENCE MANUAL 1 5

ABOUT THE STUDIO 24

The Studio 24 is an extremely flexible, 12-channel, 24-input, 2-group plus L/R

output, in-line monitor professional audio mixing console.

Channels 1 - 8 are of the familiar design that include an XLR microphone input,

balanced line input, trim control, equalization section, aux sends and pan knob. In

addition, the Studio 24 incorporates an in-line monitor system and each channel has

a level control and knob that pans the signal between the two outputs.

Channels 9 through 16 are actually four stereo line-input channels and are labeled

accordingly (9/10, 11/12, etc.) They use paired 1/4” line inputs that are ideally

suited for synthesizers, samplers, sound modules, drum machines and the like.

During the mixdown of an 8-track recording, you can also use the LINE IN jacks on

Channels 1 - 8 for an additional 8 “virtual tracks”.

This flexible design allows full mix control of 24 sources (8 tape returns plus 16 line

inputs for MIDI virtual tracks), plus 4 aux returns, for a total of 28 sources at

mixdown. For this reason, the Studio 24 is perfectly suited for professional project

studios with a large number of MIDI sequencer-controlled sources that are

synchronized with 8 tracks of ADAT.

The MONITOR 1/2 path of each channel has its own volume and pan. The

MONITOR 1/2 mix may be linked to the main stereo output, but also features its

own 1/4” output jacks on the back panel and may be heard in the Control Room or

Headphones.

Unlike Channels 1 - 8, instruments plugged into the stereo channels are routed to

MON 1/2 and the Channel FADER simultaneously. Note that both PAN controls

(one for Monitor and one for the Fader) are called BAL (balance) since the channel

routes the signal of two different sources.

Each channel features a high-quality 3-band equalizer with a frequency-adjustable

midrange control on channels 1 - 8 (inputs 9 - 16 have fixed midrange controls). A

switchable 75 Hz high-pass filter on channels 1 - 8 removes low frequency rumble

and noise.

The Studio 24 uses fully balanced +4 dBu inputs on 1/4" jacks for all LINE IN

connections. The Studio 24 may also be used with unbalanced -10 dBV level

equipment. Each channel has its own unbalanced RCA Direct Out, so that

simultaneous 8-track recording is possible.

Channels 1 - 8 feature a high-quality, low-noise balanced microphone preamp with

globally switchable 48-volt phantom power for condenser microphones. Each input

channel features a green “-20 dB signal present” LED and a red PEAK LED to warn

of input signals that are too high for the present trim or EQ setting. The MUTE and

SOLO switches use these same LEDs to indicate when a channel is muted or soloed.

Effects mixes are handled by two post-fader Aux send busses, with two controls in

each channel that vary the amount of signal to either Aux 3 or Aux 4. These two

sends are always sourced from the channel fader.

Two Stereo Aux Returns (labeled A and B) are provided, each with its own

assignment switches. Returns may be routed to the stereo mix, the groups, and

soloed to the control room, so that effects may be added to the final mix, printed to

multitrack, monitored on headphones, or any combination desired. The Studio 24

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 104 105

Komentáře k této Příručce

Žádné komentáře

Alesis 24 Specifikace Strana 16

Komentáře k této Příručce

Související produkty a manuály pro Směšovače zvuku Alesis 24