Alesis 24 Specifikace stáhnout pdf (Strana 84)

Description of Controls

STUDIO 24 REFERENCE MANUAL 8 3

HEADPHONE LEVEL

The LEVEL knob sets the overall level of the headphone output jack. The

Headphones get the same signal appearing at the Control Room outputs (but

independent of the Control Room’s level control).

HEADPHONE JACK

The headphone jack on the top panel is designed for most stereo headphones. The

internal headphone amplifier outputs the maximum power allowed by safety

standards. The impedance and efficiency of the headphones will determine the

maximum volume available. Eight-ohm headphones may be louder at a given setting

than 150-ohm or 600-ohm headphones; however, there should be enough gain to

drive any dynamic headphone to reasonable levels if the mixer is being run properly.

GRP ASSIGN SWITCHES

Press these switches if you want to record an effect (or other device plugged into the

Stereo Aux Return inputs) onto the multitrack. These switches route the signals from

the Stereo Aux Return jacks to the GRP 1/2 FADERs, with the left AUX input going

to GRP 1 and right AUX going to GRP 2. The Left input jack is mono, so if no plug is

inserted into the Right input, the left signal will be connected to both sides,

appearing in the center of the stereo image.

SOLO IN PLACE SWITCH

The SOLO IN PLACE switches in the Stereo Aux Returns are a special kind of SOLO

switch to allow you to hear the effect returns in the Control Room mix. It sends the

return’s post-fader signal (and only that Monitor’s signal, if no other SOLO buttons

are pressed) directly to the Control Room monitors, cutting off any other signals to

the Control Room.

MONITOR 1/2 MASTER

This purple knob is the final overall level control for the Monitor 1/2 mix (the 12

controls to its left, plus the two in the Stereo Aux Return section). This controls the

level at the MONITOR OUTS 1 and 2 jacks on the back panel and the MON 1/2

switch in the Control Room section. Adjust the Monitor 1/2 Master for the correct

level feeding your external headphone or stage monitor amplifier. The nominal

(unity gain) setting for this control is approximately “2 o’clock.” Set it there if the

MON 1/2 mix will be used to add more inputs to the final mix using the LINK

switch, described below.

LINK TO L/R SWITCH

This is a powerful switch that allows you to turn the Studio 24 into a 28-input stereo

mixer, instead of a 16-input mixer with an in-line monitor section. The LINK TO L/R

switch routes the MONITOR 1/2 MASTER signal to the Master L/R FADER.

Regardless of whether the LINK switch is up or down, the MONITOR 1/2 signal

always feeds the control room and headphone source switch, as well as the

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 104 105

Žádné komentáře

Alesis 24 Specifikace Strana 84